Opsview odw not updating

You'll find comprehensive guides and documentation to help you start working with Opsview Monitor as quickly as possible, as well as support if you get stuck. These instructions are intended to take an Opsview Monitor system running in one location and migrate it to another location. Depending on the goal of the migration, the installation of Opsview Monitor at the new location might include installing a newer version of the product. Note: All steps are to be performed as the root user unless stated otherwise. X, this is accomplished as follows: /opt/opsview/watchdog/bin/opsview-monit -g opsview stop 2. /usr/local/nagios/etc/sw/* (directory with all files within) 5.

It is not possible to set a freshness value on the Host state as Hosts are only checked on demand and thus will not have regular results sent to the Opsview Monitor master. This is because the reload expects to be able to communicate with all slave nodes.

If a slave is not working, then the reload will fail.

It is possible to temporarily deactivate a slave system to allow the reload to continue.

This will provide automatic load balancing between nodes within the cluster and all checks will automatically fail over if one of the nodes in that cluster fails.

See slave clusters for more information on setting up and configuring slave clusters.

Search for opsview odw not updating:

opsview odw not updating-37opsview odw not updating-77

The repos can be enabled using the following command(s).

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “opsview odw not updating”